Stock #019783 -

Heading to shop for new or rebuilt engine install.

This will prep the boat for serious fishing, so HURRY!

An impressive history comes with this 'READY-TO-FISH' center console.

Pequot boats of Warwick, RI built this hull in 1998 (200 vessel hours). Boston Whaler bought the mold when HiLiner went under, retaining the mold and subsequently building 4 prototype boats called the Yankee Voyager.

This mold is where the Boston Whaler Yankee Voyager came from in the 70's. The mold still exists and is still being built by Nauset Marine of Cape Cod, MA.

Nauset produced this hull for several years before selling the mold to Pequot boats where this particular Whaler mold was birthed. These designs were recognized in a state and/or federal contract bid for several to be built for use by different departments (environmental, safety and law). The design passed and the contract was fulfilled.

This hull went into storage after approximately 30 hours of use. It remained in storage for 13 years until the current owner of Seaward Boat Works discovered it

The current owner purchased it and over-hauled the entire boat (paint, wiring, electronics, power, hardware). The hull has seen less than 200 hours of water time. The motor has less than 150 hours and the outdrive less than 50 hours.

For fishing, this boat comes with..........

- Leaning Posts (Fwd, Aft)
- Rod Holders
- Rod Storage
- Tackle Storage
- Fish Boxes
- Large Coolers
- Fwd Seating
- Raymarine A65 (does it all, sonar capable)
- Load Rite 5-Starr Trailer (incl.)