Contact Seller
Used Landing School Flyfisher Center Console Fishing Boat For Sale 45 pictures

Boat Description

The Flyfisher 22 is a handsome center console with a bit of Downeast Maine styling. Designed by Van Dam Custom Boats specifically for saltwater flyfishing in the Northeast, the Flyfisher 22 is ideal for both close inshore breaking surf and shallow protected water. The boats performance range is between 32 and 50 mph with a range of approximately 200 nm staying in the suggested power range of 90-150 hp. With high fuel efficiency and low maintenance, this boat allows owners to explore and fish in a variety of conditions and bottoms. The hull is cold-molded using WEST SYSTEM 105/206 epoxies. Four laminated layers of Alaskan Yellow Cedar are on the topsides and bottom; the transom is built of marine plywood (Meranti) with a solid mahogany overlay. All transverse and fore-aft structures are also built of marine plywood. The very stiff hull is covered with 10oz E-glass and epoxy resin, faired with WEST SYSTEM, and primed and painted with AWLGRIP creating a finish comparable to any fiberglass boat. The Flyfisher 22 features a spacious cockpit with casting platforms forward and aft, center console and leaning post fabricated with WEST SYSTEM. Console and I-post built out of 18mm Okume Marine Plywood. Varnished Sipo makes this boat stand out from all other fishing boats of its size and weight. All deck hardware is stainless steel and flush-mounted keeping line snags to a minimum. Dry storage is available fore and aft in six separate lockers located below the casting platforms with secure rod storage for four 10 6 rods and reels. Cockpit sole, side decks and casting platforms are fiber-glassed, painted with AWLGRIP and coated in non-skid.

Dual Axle Aluminum Trailer Included in Sale!

Additional Specs, Equipment and Information:

LOA: 21 ft 7 in
Beam: 8 ft 7 in
Maximum Draft: 1 ft 2 in
Dry Weight: 4268 lbs

Total Power: 150 HP

Engine 1:
Engine Brand: Envinrude
Year Built: 2012
Engine Model: E-Tec
Engine Type: Outboard 2S
Engine/Fuel Type: Gas/Petrol
Propeller: 3 blade propeller
Engine Power: 150 HP

Cruising Speed: 30 knots
Maximum Speed: 50 knots

Fuel Tanks: (54 Gallons)


– Full engine instrumentation
– Icom IC-M412 VHF
– Ritchie F83 compass
– Fusion Marine Radio w/ 2 Speakers
– Garmin 546s

Mechanical / Electrical

– Aluminum fuel tank, fuel capacity 54 gallons
– Two 750-amp batteries
– Battery switch
– Custom waterproof control panel with circuit breakers
– AFI Horn Deck/Courtesy LED lighting
– LED center bow mounted port/starboard LED navigation lights
– Electric bilge pump with float switches
– Water/fuel separator filter
– 13.5 stainless helm wheel with power knob
– Pressure Salt Water wash down system with bronze thru-hull and sea cock

Deck / Hull / Cockpit

– All structural adhesive is WEST SYSTEM epoxy
– Bottom: cold-molded Alaskan Yellow Cedar
– Topsides: cold-molded Alaskan Yellow Cedar
– Hull sheathed with fiberglass for abrasion resistance
– AWLGRIP topside with contrasting boot top
– Antifouling bottom paint
– Non-skid deck and cockpit sole
– Varnished Sipo toerail, coaming and trim
– Stainless steel rubrail
– 8 bow cleat with G-10 chafe protection; chafing strip is #316 SS
– 6 stern and spring cleats; all cleats are: GEMLUX Flush mount Pull-Up
– 7# Fortress anchor w/ chain and 100 of rode
– Stainless steel custom handrails on console
– Sunbrella cover for console and leaning post
– U.S. Coast Guard safety package


The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.

Approximate boat location: Aventura, Florida